Extremely high sensitivity and excellent stability offered in a very neat small size. With splendid abilities ranging from the formation of a Wheatstone full bridge, without additional external resistance, to the ability to output millivolt voltage signals under standard operating power supply. a calibrated output optional, with the help of a conditioning chip. Especially designed to fit-in perfectively in tire pressure monitoring system, wind tunnel, air pump, water pump and internal pressure monitoring technology.
High standards, no pressure. The New pressure sensor, dubbed “SAL4-XS02” by acoustics pioneer SOUND COMPONENTS LIMITED, is here and ready to heighten-up the pressure level. This chip’s integrated force resistor can form a Wheatstone full bridge, used to measure unknown electrical resistance, without additional external resistance. It can also be combined with a conditioning chip to give a calibrated output. Furthermore, it can produce a millivolt voltage signals output under standard operating power supply. Thus, this new top-notch sensor offers extremely high sensitivity and excellent stability in a very small size- truly bringing it’s A game to the word Absolute.
Delivering good stability, low noise and low power consumption operability, this solution takes the wind out of the sails of any reliability-deliberated concern. At least in all things air, or air monitored, related. With a Burst Pressure reaching as high as 7000 kPa, Storage and Operating temperatures ranging from -40°C to 125°C and a Pressure range reaching at Maximum 700 kPa- This unpressured (in-terms-of-quality) pressure sensor is above and beyond the standard mundane chip out there on the field. with an extremely highly sensitive performance (0.0624 at minimum, 0.078 at typical and 0.0936 mV/Kpa respectively) and Wheatstone Bridge Resistor activity with values of 8 k? at minimum to 10 k? at maximum, there is a sense you got the real deal.
Additionally, This sensor can be used in tire pressure monitoring system, wind tunnel, air pump, water pump and to help monitor the internal pressure of systems. Regarding soldering processes, there is a clarification that one must minimize the influence of external heat, otherwise it may be damaged due to thermal deformation, causing characteristic changes. Use a non-corrosive rose-scented flux. In addition, please be careful not to allow the flux to invade the interior.